CONSTRUCTION
Sound Absorption and Insulation Structure
Various types of silencers are positioned around the floor panel and engine compartment to greatly suppress vibration and noise that are transmitted into the interior from parts such as the engine and tires, achieving superior quietness. Also, materials such as foamed materials, sound insulation sealant and damping materials are optimally positioned to achieve superior NVH* performance.
*: An abbreviation created by taking the first letter of Noise (unpleasant sounds and loud sounds), Vibration (vibrations from the engine and tires) and Harshness (vibrations felt through the steering wheel, seats and floor according to height changes in the road surface, etc.). NVH is used to describe the level of riding comfort and sound quality actually experienced by passengers.
Floor Silencer
The floor silencer (coating-type applied damping materials), which is applied at optimal thickness that varies by the area, is lightweight and provides excellent quietness. These characteristics allow the floor silencer to reduce the amount of road and engine noise that enters the cabin.
By applying the damping material at varying levels of thickness, optimal damping performance has been achieved.
Sound Absorption and Insulation Structure around Engine Compartment
By adopting a fender separator, hood insulator, outer dash panel insulator and engine under cover center, the coverage area of sounds absorbing and insulating material has been increased, achieving a high level of noise reduction.
| *1 | Outer Dash Panel Insulator | *2 | Fender Separator |
| *3 | Hood Insulator | - | - |
| *a | A - A Cross Section | - | - |
By configuring foam material on the front body pillar, center body pillar, rear body pillar and front header panel, the amount of engine noise and road noise entering the cabin were reduced.
| *A | Front Body Pillar | *B | Front Header Panel |
| *1 | Foamed Materials | - | - |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | D - D Cross Section |
| *e | E - E Cross Section | *f | F - F Cross Section |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | D - D Cross Section |
| *e | E - E Cross Section | *f | F - F Cross Section |
By optimizing the thickness and mass per unit area of the dash panel insulator assembly, the interaction between the dash panel insulator assembly and the surrounding parts has been reduced as much as possible to improve sound absorption and insulation.
| *1 | Dash Panel Insulator Assembly | *2 | No. 1 Front Panel Side Silencer |
| *3 | Front Panel Silencer | - | - |
| *a | The illustrations shown are examples only. | - | - |
Steering Column Hole Cover
By optimizing the thickness of the dash panel sub-assembly, the body vibration characteristics were enhanced to reduce road noise and engine noise.
A steering column hole cover has been provided to reduce the size of the steering shaft opening and thus reduce the amount of road noise and engine noise transmitted via the steering shaft through hole.
| *1 | Dash Panel Sub-assembly | *2 | Steering Column Hole Cover |
| *a | The illustrations shown are examples only. | - | - |
Rear Wheel House Liner
The rear wheel house liner is set inside the rear wheel house to reduce road noise from the rear wheel house.
| *1 | Rear Wheel House Liner RH | *2 | Rear Wheel House Liner LH |
Door
By using door seals and resin service hole covers for the front and rear doors, high noise reduction has been achieved.
| *1 | Front Door Service Hole Cover RH | - | - |
Floor Panel
An upper and lower split type has been adopted for the dash panel that was traditionally single-piece integrated type.
A beat shape and coating type damping material on the front floor to improve the body vibration characteristics, thereby reducing road noise.
| *a | Coating Type Damping Material | - | - |
| *a | Coating Type Damping Material | - | - |