Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM (for HV Model TMC Made) › from 2020.07
NM36W0E _54 Brake _088478 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0434643 BRAKE CONTROL SYSTEM(for HV Model TMC Made) CO CONTROL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM(for HV Model TMC Made)  CONTROL  EMERGENCY BRAKE SIGNAL  


SYSTEM CONTROL


a.

When emergency braking, the emergency brake signal function automatically flashes the hazard warning lights in order to reduce the risk of being rear ended by a proceeding vehicle.


b.

When the skid control ECU determines that it is necessary to operate the emergency brake signal function based on the signals received from each sensor and the operation of the brake pedal, it sends an emergency braking signal request signal to the combination meter assembly. With this, the combination meter assembly flashes the hazard warning lights.


c.

When the hazard warning lights are turned on by operating the hazard warning signal switch assembly, the emergency brake signal function is prohibited.

i.

Operation conditions of the emergency brake signal

·

The vehicle speed is approximately 55 km/h or more.

·

The brake pedal is depressed and the vehicle is judged to be rapidly braking based on the deceleration rate.




ii.

Cancellation conditions of the emergency brake signal

·

When the hazard warning lights are turned on by operating the hazard warning signal switch assembly.

·

The brake pedal is released.

·

The vehicle is judged not to be rapidly braking based on the deceleration rate.