FUNCTION OF MAIN COMPONENTS
| Component | Function | |
|---|---|---|
|
*: Models with Toyota Safety Sense |
||
| Brake Master Cylinder Reservoir Assembly | Brake Fluid Level Warning Switch | Detects the brake fluid level. |
| Brake Actuator Assembly | Solenoid Valves | Change the fluid path based on the signals from the skid control ECU during the operation of the brake control system functions in order to control the fluid pressure applied to the wheel cylinders. |
| Pump Motor | Drives the pumps inside the brake actuator. | |
| Master Cylinder Pressure Sensor | Detects the master cylinder pressure. | |
| Solenoid Relay (Built into Skid Control ECU) | Supplies power to the solenoid valves. | |
| Motor Relay (Built into Skid Control ECU) | Supplies power to the pump motor. | |
| Skid Control ECU | ·
Judges the vehicle driving condition based on the signals from each ECU, sensor and switch, and sends the brake control signals to the brake actuator. ·
Requests steering torque assist during cooperative control with EPS. |
|
| Speed Sensor | Detects the wheel speed of each of the 4 wheels. | |
| Airbag Sensor Assembly | Yawrate Sensor | Detects the vehicle's yaw rate. |
| Deceleration Sensor | Detects the vehicle's acceleration in the forward, rearward, and lateral directions. | |
| Steering Sensor | Detects the direction and angle of the steering wheel. | |
| Stop Light Switch Assembly | Detects the brake pedal depression signal. | |
| Parking Brake Switch Assembly | Outputs the parking brake operation status to the main body ECU (multiplex network body ECU). | |
| VSC OFF Switch | Enables the driver to select normal mode, TRC OFF mode or VSC OFF mode. | |
| Forward Recognition Camera* | Sends brake request signals to the skid control ECU. | |
| ECM | Controls the drive force when TRC and VSC are operating according to communication with the skid control ECU. | |
| Power Steering ECU Assembly | Power Steering ECU | Controls the steering assist torque based on the signals received from the skid control ECU. |
| Main Body ECU (Multiplex Network Body ECU) | Transmits the parking brake switch signal to the skid control ECU. | |
| Central Gateway ECU (Network Gateway ECU) | Relays data between buses. | |
| Combination Meter Assembly | Each of the lights and buzzers inform the driver of system operations, malfunctions, or control restriction conditions. Also, messages are displayed on the multi-information display in response to system abnormalities and system malfunction. | |
FAIL-SAFE
If a failure occurs in the skid control ECU, sensors or brake actuator assembly, the system continues effecting brake control by excluding the failed area and using only the areas that are operating normally.
DIAGNOSIS
If the skid control ECU detects a malfunction in the brake control system, the warning lights or indicator light illuminate. At the same time, a Diagnostic Trouble Code (DTC) is stored in the memory of the skid control ECU.
This system has a sensor signal check (test mode) function.
For details of DTCs and check function, refer to the Repair Manual.