CONSTRUCTION
An integrated input construction type front suspension support sub-assembly (fastened to the body as a single unit) is used.
Through optimization of the rigidity of the rubber of the front suspension support sub-assembly, vibrations from the road surface are reduced while ensuring steering responsiveness and achieving excellent controllability and ride comfort.
A urethane front spring bumper is used to attain non-linear spring characteristics, which reduces the impact generated when the suspension reaches full travel, achieving both smoother ride comfort as well as stabilization of vehicle posture with regard to roll, pitch, etc.
A semi-airtight shock absorber dust cover which moves with the shock absorber has been adopted. The bottom of the semi-airtight shock absorber dust cover is attached to the absorber cap and the top is attached to the upper seat. This reduces the gap between the front No. 1 shock absorber dust cover and shock absorber assembly, enhancing its ability to resist the intrusion of foreign matter.
| *1 | Front Suspension Support Sub-assembly | *2 | Front Spring Bumper |
| *3 | Absorber Cap | *4 | Front No. 1 Shock Absorber Dust Cover |
| *a | The illustrations shown are examples only. | - | - |