Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › from 2020.07
NM36W0E _59 Vehicle Exterior _088686 LIGHTING (EXT) _0422146 LIGHTING SYSTEM CO CONTROL F

LIGHTING (EXT)  LIGHTING SYSTEM  CONTROL  EMERGENCY BRAKE SIGNAL  


FUNCTION OF MAIN COMPONENTS


Component Function

*1: Gasoline Models

*2: HV Models with brake booster with master cylinder assembly

*3: HV Models with brake master cylinder with motor assembly

Brake Booster with Master Cylinder Assembly*2
·

Skid Control ECU


Receives various signals and sends an emergency brake signal to combination meter assembly.
Brake Actuater Assembly*1,*3
·

Skid Control ECU


Speed Sensors Detect the wheel speed of each of the 4 wheels and sends signals to the skid control ECU.
Airbag Sensor Assembly Sends the acceleration information to the skid control ECU.
Stop Light Switch Assembly Detects the brake pedal depressing signal and sends a signal to the skid control ECU.
Combination Meter Assembly Receives an emergency brake signal and turns on the hazard warning lights.
Hazard Warning Signal Switch Assembly Sends a hazard warning switch on signal to the combination meter assembly.


SYSTEM CONTROL


a.

The activating and deactivating conditions for the emergency brake signal are as shown in the following table:

Condition Details
Emergency Brake Signal Operating Conditions When all of the following conditions are met, the emergency brake signal starts operating:
·

Vehicle speed is above 55 km/h (35 mph).

·

Driver is depressing the brake pedal.

·

Emergency braking is detected from the vehicle deceleration.


Emergency Brake Signal Ending Conditions When any of the following conditions is met, the emergency brake signal stops operating:
·

Driver has released the brake pedal.

·

Emergency braking is no longer detected from the vehicle deceleration.

·

Driver has operated the hazard warning switch.