FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
| Fuel Injector Assembly | Injects fuel to the combustion chamber in accordance with ECM signals. |
| Crank Position Sensor | Detects the engine speed and performs cylinder identification. |
| Transmission Revolution Sensor | Detects the input speed of the transmission. |
| Speed Sensor | Detects the wheel speed. |
| Clutch Pedal Stroke Sensor Assembly | Detects the amount of pedal effort applied to the clutch pedal. |
| Accelerator Pedal Position Sensor | Detects the amount of pedal effort applied to the accelerator pedal. |
| Combination Switch Assembly
·
iMT Switch |
Switches the iMT system on/off. |
| ECM | Controls the engine speed based on signals from each sensor and switch. |
| Combination Meter Assembly
·
Multi-information Display |
·
Displays the iMT indicator (green) when the system is in the standby condition. ·
Displays the message when there is a malfunction in the system. |
| Brake Actuator Assembly
·
Skid Control ECU |
Transmits the wheel speed signal to the ECM. |
FUNCTION
Shift Synchronization Function
The iMT system detects shift changes from the driver (depressing the clutch pedal and operating the shift lever) and synchronizes the engine speed with the transmission input speed after a shift change, achieving a smooth and comfortable shift feeling.
This system operates when the iMT switch is operated and the iMT indicator (iMT system standby condition) is displayed in the combination meter.
When Upshifting
- Control is performed so that the engine speed after a shift change does not drop below the transmission input speed and to reduce the shock caused when the clutch is engaged, achieving a smooth shift feeling.
When Downshifting
- After a shift change, the engine speed is raised to synchronize with the transmission input speed, reducing the shock caused when the clutch is engaged and achieving a smooth shift feeling.
Idle Take-off Assist Function
This system performs control even in the iMT Standby and iMT OFF modes.
When a brake system function such as brake hold is operating, and the driver attempts to perform take-off using the clutch only, the system will display a message in the multi-information display to inform the driver that accelerator pedal operation must be performed in order to release the brake system.
FAIL-SAFE
If a system malfunction occurs, iMT system control is canceled, in addition, a message is displayed on the multi-information display in the combination meter in order to inform the driver of the system malfunction.
DIAGNOSIS
To make diagnosing the system easier, a diagnosis function is provided for enhanced serviceability, for details about the diagnosis function, refer to the Repair Manual.