CONSTRUCTION
An aluminum cylinder block sub-assembly is used to achieve a lightweight design.
The liners are a spiny-type, which have been manufactured so that their casting exteriors form large irregular surfaces in order to enhance the adhesion between the liners and the aluminum cylinder block sub-assembly. The enhanced adhesion helps heat dissipation, resulting in a lower overall temperature and reduced heat deformation of the cylinder bores.
The oil level dipstick passage is built into the cylinder block sub-assembly, and also functions as the blowby gas ventilation passage, enabling the engine to be more compact.
Two systems of oil drain passages that connect directly to the oil pan are provided, suppressing churning in the oil sump due to oil drop, and providing enhanced resistance to air intake at the oil strainer.
By adopting a shallow-bottom construction for the water jacket, the cylinder head bolt fastening force was optimized, allowing the weight of the cylinder block sub-assembly to be reduced.
Cooling passages are drilled between each cylinder bore to provide increased cooling to the upper part of the cylinder bore which is most susceptible to heat. This minimizes deformation of the cylinder bore, ensuring high power output and reduced oil consumption.
A larger breather hole is provided. As a result, friction is reduced and output performance is improved.
The angle of the bore cross hatching, the polishing on the cylinder liner surface, is at an angle of 30°, thus improving the oil retention of the interior of the cylinder bore. This reduces the friction between the cylinder bore and the piston, improving fuel consumption.
The shape of the ribs, and the positioning and shape of the knock control sensor have been optimized, thus improving control of knocking.
A gap is provided on the side surface of the crank bearing cap to prevent strong impacts to the crank bearing caused by the whirling of the crankshaft that is characteristic of in-line 3-cylinder engines, reducing friction and weight.
A crankshaft bearing cap sub-assembly with integrated bearing cap is used, providing increased rigidity of the crank journal surroundings to support higher RPM and higher output.
| *1 | Cylinder Block Sub-assembly | *2 | Crankshaft Bearing Cap Sub-assembly |
| *3 | Cylinder Liner | - | - |
| *a | Top of View | *b | Oil Drain Passage |
| *c | Oil Level Gauge Passage | *d | Cylinder Bore |
| *e | Irregularly Shaped Outer Casting Surface of Liner | *f | Bore Cross Hatch |
| *g | 30° | *h | Knock Control Sensor Installation Boss |
| *i | Side Groove | *j | A-A Cross Section |
| *k | Shallow-bottom Water Jacket | *l | Water Passage |
| *m | Larger Breather Hole | - | - |
Through the use of an offset crankshaft, the centerline of the bores is shifted 10 mm (0.394 in.) towards the intake side in relation to the centerline of the crankshaft. Thus, the side force to the cylinder wall is reduced when the maximum pressure is applied. This contributes to fuel economy.
| *a | Bore Centerline | *b | Crankshaft Center |
| *c | Intake Side | *d | Exhaust Side |
| *e | Offset | *f | Maximum Pressure |
| *g | Offset Crankshaft | *h | Non-offset Crankshaft |