Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM (for Gasoline Model) › from 2020.09
NM36W0E _54 Brake _088478 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421634 BRAKE CONTROL SYSTEM(for Gasoline Model) GE GENERAL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM(for Gasoline Model)  GENERAL  GENERAL  


OUTLINE


a.

The following brake control systems are provided: Anti-lock Brake System (ABS), Electronic Brake force Distribution (EBD), brake assist, Traction Control (TRC), Vehicle Stability Control (VSC), Active Cornering Assist (ACA), trailer sway control*, hill-start assist control, steering cooperative control, emergency brake signal and secondary collision brake.

*: TMMF Made



PRECAUTION


a.

ABS

i.

The ABS system cannot increase the performance limit of the tires. Always drive safely and be aware of the vehicle speed and distance to other vehicles.


ii.

Any non-standard components such as non-standard tires that are installed may have a negative effect on the ABS function.


iii.

When braking using ABS, the braking distance may be longer than vehicles without ABS in the following conditions:

·

When driving on a dirt road or a road covered with fresh snow

·

When using tire chains

·

When driving over a joint in the road surface

·

When driving on a rough road such as an unpaved or stone-paved road




b.

Brake Assist

i.

Brake assist cannot increase the performance limit of the fundamental brake system. Always drive safely and be aware of the vehicle speed and distance to other vehicles.



c.

TRC, VSC

i.

The TRC and VSC systems enhance traction and vehicle stability. Do not disable the TRC or VSC functions unless necessary.


ii.

The TRC and VSC systems cannot increase the performance limit of the tires. Always drive the vehicle carefully in conditions in which drive wheel traction or vehicle stability may be lost.



d.

Active Cornering Assist (ACA)

i.

Active Cornering Assist (ACA) cannot increase the performance limit or innate maneuverability of the vehicle itself.


ii.

Do not overly rely on Active Cornering Assist (ACA). Active Cornering Assist (ACA) may not operate effectively when accelerating down slopes or driving on slippery road surfaces.


iii.

When Active Cornering Assist (ACA) frequently operates, Active Cornering Assist (ACA) may temporarily stop operating to ensure proper operation of the brakes, TRC and VSC.



e.

Hill-start Assist Control

i.

Hill-start assist control is not intended to keep the vehicle stationary on a hill for a prolonged period. As hill-start assist control only prevents the vehicle from rolling backwards for 2 seconds after the brake pedal is released, perform start-off within this period.


ii.

When hill-start assist control is operating and the ignition switch (push start switch) is turned off, hill-start assist control will be canceled without warning.


iii.

Hill-start assist control prevents the vehicle from rolling backwards by controlling the brake force to the 4 wheels. However, the vehicle may not remain stationary when on an extremely steep slope or a low friction surface such as ice.



f.

EXPERT MODE

i.

Do not use EXPERT mode on public roads.


ii.

Only select EXPERT mode when you have checked the road surface, surrounding conditions, etc. and can be sure that the circumstances are safe and appropriate.


iii.

When you drive the vehicle with EXPERT mode, it is necessary for the driver to be experienced and have a high level of technical driving ability.