Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › SFI SYSTEM › 2020.03–2020.07
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0418535 SFI SYSTEM L

M15A-FXE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


WHEN USING GTS


CAUTION:
·

Strictly obey all traffic rules and regulations.

·

Do not drive the vehicle with the GTS cable contacting the pedals, shift lever or steering wheel.

·
A356952

Driving the wheel with the GTS cable contacting these areas could impede vehicle control, resulting in a serious accident.

·
A356953

Do not operate the GTS while driving the vehicle.

·

Operating the GTS while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.




INITIALIZATION


NOTICE:
·

Perform Registration (VIN registration or frame number registration) after replacing the ECM.

Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION

·

When the ECM is replaced, update the ECU security key.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY

·

Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation.

Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION




PRECAUTIONS FOR INSPECTING HYBRID CONTROL SYSTEM




NOTICE FOR HYBRID CONTROL SYSTEM ACTIVATION




DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:
·

After the ignition switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When disconnecting and reconnecting the auxiliary battery.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART