Home › Power Source / Network › M15A-FKS (BATTERY / CHARGING) › CHARGING SYSTEM › 2020.03–2020.07
RM36W0E _57 Power Source / Network _087763 M15A-FKS BATTERY / CHARGING _0419403 CHARGING SYSTEM C

M15A-FKS BATTERY / CHARGING  CHARGING SYSTEM  P161A87  Lost Communication with Alternator Missing Message  


DESCRIPTION

The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note
P161A87 Lost Communication with Alternator Missing Message Generator assembly or ECM communication stops for approximately 17 minutes or more with the ignition switch ON
(1 trip detection logic)
·

Wire harness or connector

·

Generator assembly

·

ECM


Charge warning light:
Does not come on
DTC stored SAE Code: P161A

WIRING DIAGRAM

A340530E90
1.51,3.167 5.177,3.365 3.667,0.198 10 false : LIN Communication Line 1.802,2.271 2.26,2.469 0.458,0.198 10 false D53 1.792,2.427 3.135,2.792 1.344,0.365 10 false Generator Assembly 4.844,2.521 5.302,2.719 0.458,0.198 10 false D51 4.833,2.688 6.802,3.177 1.969,0.49 10 false ECM 3.104,1.542 3.438,1.823 0.333,0.281 10 false 2 4.635,1.542 4.969,1.823 0.333,0.281 10 false 63 2.802,1.74 3.26,1.938 0.458,0.198 10 false LIN 4.896,1.719 5.354,1.917 0.458,0.198 10 false LIN

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

·

Before replacing the ECM, refer to Service Bulletin.



PROCEDURE

1.CHECK CHARGING SYSTEM

OK

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)

Pre-procedure1

a.

Disconnect the D51 ECM connector.


b.

Disconnect the D53 generator assembly connector.


Procedure1

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
D53-2 (LIN) - D51-63 (LIN) Always Below 1 Ω
D53-2 (LIN) or D51-63 (LIN) - Body ground Always 10 kΩ or higher



Post-procedure1

d.

None


Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR