Home › Drivetrain › K320 (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0419699 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM D

K320 MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  MECHANICAL SYSTEM TESTS  


SHIFT TIME LAG TEST


NOTICE:
·

This test must be performed after checking and confirming that the engine is normal.

·

Perform this test with the CVT fluid temperature between 50 and 100°C (122 and 212°F).

·

Perform this test with the air conditioning off.



HINT:

When the shift lever is moved while the engine is idling, there will be a certain time lapse or lag before shock can be felt. This is used for checking the condition of the clutches and brakes.


a.

Start the engine.


b.

Drive the vehicle until the CVT fluid temperature has reached 50 to 100°C (122 to 212°F).

Powertrain > Transmission > Data List
Tester Display
A/T Oil Temperature No.1
50003 373 180

c.

Allow the engine to idle with the air conditioning off.


d.

Apply the parking brake and keep the brake pedal depressed firmly.


e.

Check the D position time lag.

i.

Move the shift lever to N and wait for 1 minute.


ii.

Move the shift lever to D and measure the time until shock is felt.


iii.

Repeat the 2 steps above 3 times, and calculate the average time of the 3 tests.

Standard Value:

D position time lag is less than 1.2 seconds.




f.

Check the R position time lag.

i.

Move the shift lever to N and wait for 1 minute.


ii.

Move the shift lever to R and measure the time until shock is felt.


iii.

Repeat the 2 steps above 3 times, and calculate the average time of the 3 tests.

Standard Value:

R position time lag is less than 1.5 seconds.





STALL SPEED TEST


CAUTION:
·
C328184

Do not perform a stall test if there are any people or objects near the vehicle.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328186

Do not perform a stall test if any wheel chocks are out of position.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328185

Do not perform the stall test on a slippery or low-friction surface that could allow the tires to spin.

·

The vehicle could begin moving suddenly, resulting in a serious accident.



NOTICE:
·

Do not perform a stall speed test for more than 5 seconds.

·

When performing the stall speed test repeatedly, wait for 15 seconds or more between tests.



HINT:

This test is used to check the overall performance of the engine and transaxle.


a.

Start the engine.


b.

Drive the vehicle until the CVT fluid temperature has reached 50 to 100°C (122 to 212°F).

Powertrain > Transmission > Data List
Tester Display
A/T Oil Temperature No.1
50003 373 180

c.

Allow the engine to idle with the air conditioning off.


d.

Chock all 4 wheels.


e.

Enter the following menus: Powertrain / Transmission / Active Test / Activate the TC Terminal.

Powertrain > Transmission > Active Test
Tester Display
Activate the TC Terminal
50004 373 22

f.

Apply the parking brake and firmly depress the brake pedal with your left foot.


g.

Move the shift lever to D.


h.

Depress the accelerator pedal as much as possible with your right foot.


i.

Quickly read the engine speed (stall speed) and release the accelerator pedal immediately.

Stall Speed:

2300 +/- 400 rpm