Home › Drivetrain › K320 (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0419699 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM D

K320 MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  HYDRAULIC TEST  


PERFORM HYDRAULIC TEST


CAUTION:
·
C328184

Do not perform a stall test if there are any people or objects near the vehicle.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328186

Do not perform a stall test if any wheel chocks are out of position.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328185

Do not perform the stall test on a slippery or low-friction surface that could allow the tires to spin.

·

The vehicle could begin moving suddenly, resulting in a serious accident.



a.

Measure the secondary oil pressure.

CAUTION:

A secondary oil pressure test should always be carried out with at least 2 people. One person should observe the condition of the wheels and wheel chocks while the other is performing the test.


NOTICE:
·

This test must be performed after checking and confirming that the engine is normal.

·

Perform this test with the CVT fluid temperature between 50 and 100°C (122 and 212°F).

·

Perform this test with the air conditioning off.

·

Do not perform the stall speed test for more than 5 seconds.

·

When performing the stall speed test repeatedly, wait for 15 seconds or more between tests.



i.

Fully apply the parking brake and chock all 4 wheels.


ii.

Start the engine.


iii.

Enter the following menus: Powertrain / Transmission / Active Test / Activate the TC Terminal.

HINT:

Observe the value of Belt Clamping Force Sensor in the Data List while performing the Active Test.


Powertrain > Transmission > Active Test
Active Test Display
Activate the TC Terminal
Data List Display
Belt Clamping Force Sensor
50004 373 22 367

iv.

Keep your left foot firmly on the brake pedal and move the shift lever to D.


v.

Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest secondary oil pressure reading when the engine speed reaches stall speed and release the accelerator pedal immediately.


vi.

Keep your left foot firmly on the brake pedal and move the shift lever to R.


vii.

Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest secondary oil pressure reading when the engine speed reaches stall speed and release the accelerator pedal immediately.

Specified Secondary Oil Pressure:
Stall Speed Shift Lever Position Secondary Oil Pressure
2300 +/- 400 rpm D 3.4 to 4.2 MPa
(34.7 to 42.8 kgf/cm2, 493 to 609 psi)
R 2.4 to 3.2 MPa
(24.5 to 32.6 kgf/cm2, 348 to 464 psi)


HINT:

If the secondary oil pressure is out of the specified range, a solenoid valve, regulator valve or modulator valve may be malfunctioning.