The TCM memory contains programs for normal and PWR shift patterns.
By following the programs corresponding to signals from the combination switch assembly (drive mode switch), park/neutral position switch assembly and various other sensors, the TCM turns the shift solenoid valves on and off, and controls the transaxle gear ratio.
Perform registration and/or initialization when parts related to the continuously variable transaxle system are replaced.
Click hereDrivetrain>K320 (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>PRECAUTION
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Drive Mode Select Switch | Combination switch assembly (drive mode switch) status | ON or OFF | ·
ON: Combination switch assembly (drive mode switch) being pushed ·
OFF: Combination switch assembly (drive mode switch) not being pushed |
- |
| Tester Display |
|---|
| Drive Mode Select Switch |
| Result | Proceed to |
|---|---|
| Data List value is normal | A |
| Data List value is not normal | B |
A
B
NEXT
OK
NG
Disconnect the combination switch assembly (drive mode switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H18-5 (E) - Body ground | Always | Below 1 Ω |
Connect the combination switch assembly (drive mode switch) connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the combination switch assembly (drive mode switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A54-31 (PDRV) - H18-8 (MSW1) | Ignition switch off | Below 1 Ω |
| A54-31 (PDRV) or H18-8 (MSW1) - Body ground | Ignition switch off | 10 kΩ or higher |
Connect the combination switch assembly (drive mode switch) connector.
Connect the ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
NEXT