ALL READINESS
With "All Readiness", you can check whether or not the DTC judgment has been completed by using the GTS.
You should check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.
Clear the DTCs even if no DTCs are stored.
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON.
Perform the DTC judgment driving pattern to run the DTC judgment.
| Tester Display |
|---|
| All Readiness |
Input the DTC to be confirmed.
Check the DTC judgment result.
| GTS Display | Description |
|---|---|
|
If the judgment result shows INCOMPLETE or N/A, perform the DTC confirmation driving pattern again. |
|
| NORMAL | ·
DTC judgment completed ·
System normal |
| ABNORMAL | ·
DTC judgment completed ·
System abnormal |
| INCOMPLETE | ·
DTC judgment not completed ·
Perform the driving pattern |
| N/A | ·
Unable to perform DTC judgment ·
Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit ·
Perform the driving pattern |
Turn the ignition switch off.
DIAGNOSIS RELATED INFORMATION
Check for diagnosis related information.
| Tester Display |
|---|
| Diagnosis Related Information |
Check the Diagnosis Related Information, and then write them down.
Clear diagnosis related information.
Clearing the DTCs will also clear the diagnosis related information.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Clear the diagnosis related information and freeze frame data.
Turn the ignition switch off.