The motor generator control ECU communicates with the hybrid vehicle control ECU, ECM and skid control ECU assembly via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| U010087 | Lost Communication with ECM/PCM "A" Missing Message | A CAN communication error between the ECM and motor generator control ECU (CAN communication system malfunction) occurs
(1 trip detection logic) |
CAN communication system | Comes on | Master Warning:
Comes on |
| U029387 | Lost Communication With Hybrid Powertrain Control Module Missing Message | A CAN communication error between the hybrid vehicle control ECU and motor generator control ECU (CAN communication system malfunction) occurs
(1 trip detection logic) |
CAN communication system | Comes on | Master Warning:
Comes on |
| U117087 | Lost Communication With Brake System Control Module(ch2) Missing Message | A CAN communication error between the skid control ECU assembly and motor generator control ECU (CAN communication system malfunction) occurs
(1 trip detection logic) |
CAN communication system | Does not come on | Master Warning:
Comes on |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM>UTILITY
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for 2 minutes or more.
Turn the ignition switch to ON and wait for 2 minutes or more.
Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.
Check the DTC judgment result.
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.
Pre-procedure1
None.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| None of the following DTCs are output | A |
| Any of the following DTCs are also output | B |
| DTC No. | Relevant Diagnosis |
|---|---|
| P312487 | Lost Communication between Drive Motor "A" and HV ECU Missing Message |
U010087, U029387 or U117087 may be stored due to a malfunction which also causes the DTCs in the preceding table to be stored. In this case, first troubleshoot the output DTCs in the preceding table. Then, perform a test to attempt to reproduce the problems, and check that no DTCs are output.
Post-procedure1
Turn the ignition switch off.
A
B