Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model) › 2020.03–2020.07
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0420272 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model) D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model)  DIAGNOSIS SYSTEM  


DESCRIPTION


When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the vehicle's skid control ECU (brake actuator assembly).

The skid control ECU (brake actuator assembly) records DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.

To check the DTCs, connect the GTS to the DLC3 on the vehicle. The GTS enables you to clear the DTCs, activate the various actuators, and check the Freeze Frame Data and Data List.

a.

Check the auxiliary battery voltage.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge the auxiliary battery before proceeding to the next step.




DIAGNOSIS


a.

If a malfunction occurs in one part of the system, the skid control ECU (brake actuator assembly) illuminates the warning light corresponding to the malfunctioning system (ABS warning light, brake system warning light or slip indicator light).


b.

The DTCs are simultaneously stored in memory. The DTCs can be read by connecting the GTS.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DTC CHECK / CLEAR




WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK


a.

When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light, VSC OFF indicator light and slip indicator light come on for approximately 3 seconds.

HINT:
·

When the brake fluid level is low, the brake system warning light comes on.

·

If a light does not illuminate, check the communication line between the combination meter assembly and skid control ECU (brake actuator assembly).

·

If the ABS warning light or slip indicator light remains illuminated after approximately 3 seconds check for DTCs and check the corresponding code. If no DTC is output, check the communication line between the combination meter assembly and skid control ECU (brake actuator assembly).



Trouble Area See procedure
ABS warning light circuit (Remains on) (Click here)
ABS warning light circuit (Does not come on) (Click here)
Brake warning light circuit (Remains on) (Click here)
Brake warning light circuit (Does not come on) (Click here)
VSC OFF indicator light circuit (Remains on) (Click here)
VSC OFF indicator light circuit (Does not come on) (Click here)
Slip indicator light circuit (Remains on) (Click here)
Slip indicator light circuit (Does not come on) (Click here)