The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C00631F | Yaw Rate Sensor Circuit Intermittent | When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from yaw rate sensor is ON continuously for 10 seconds or more. | Yaw rate sensor (airbag sensor assembly) | Brake |
| C05201F | Multi-axis Acceleration Sensor Module "A" Circuit Intermittent | When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from acceleration sensor is ON continuously for 10 seconds or more. | Acceleration sensor (airbag sensor assembly) | Brake |
If the yaw rate and acceleration sensor (airbag sensor assembly) was replaced or reinstalled, perform "Calibration".
Operate the GTS to clear the codes.
Press the DTC clear button.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Start and idle the engine for 60 seconds, and then stop the engine.
Procedure1
Operate the GTS to read the DTCs.
Check if the same DTC is output.
Post-procedure1
None
| Result | Proceed to |
|---|---|
| C00631F and C05201F are not output | A |
| C00631F or C05201F is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B