The outer mirror switch assembly sends a mirror auto retract/return signal to the main body ECU (multiplex network body ECU) when the retractable outer mirror switch on the outer mirror switch assembly is in the AUTO position. The main body ECU (multiplex network body ECU) retracts or returns the outer rear view mirror assemblies based on the lock/unlock signal of each door while the ignition switch is off.
Inspect the fuses for circuits related to this system before performing the following procedure.
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
Check the power retract mirror function.
Click hereVehicle Exterior>MIRROR (EXT)>POWER MIRROR CONTROL SYSTEM>OPERATION CHECK
Power retract mirror function operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the power door lock control system.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
Power door lock control system is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check the wireless door lock control system.
w/ Entry and Start System
w/o Entry and Start System
Wireless door lock control system is normal.
| Proceed to | |
|---|---|
| OK (w/ Entry and Start System) | A |
| OK (w/o Entry and Start System) | B |
| NG (w/ Entry and Start System) | C |
| NG (w/o Entry and Start System) | D |
A
B
C
D
Check the smart entry and start system (for Entry Function).
Smart Entry and start system (for Entry Function) is normal.
| Proceed to | |
|---|---|
| OK | A |
| NG (for HV Model) | B |
| NG (for Gasoline Model) | C |
A
B
C
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Outer Mirror Auto Switch | Retractable outer mirror switch signal | OFF or ON | OFF: Retractable outer mirror switch not in auto position
ON: Retractable outer mirror switch in auto position |
- |
| Tester Display |
|---|
| Outer Mirror Auto Switch |
On the GTS screen, ON or OFF is displayed accordingly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
OK
NG
Disconnect the H5 main body ECU (multiplex network body ECU).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K12-9 (MAT) - H5-26 (AMR) | Always | Below 1 Ω |
| K12-9 (MAT) or H5-26 (AMR) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG