CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY
| *1 | INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY | *2 | MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Connect the power distribution box assembly connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| MB-26 (BECU) - Body ground | Auxiliary battery power supply | Ignition switch off | 11 to 14 V |
| MB-27 (IGR) - Body ground | Ignition power supply (IG signal) | Ignition switch ON → off | Below 1 V → 11 to 14 V |
| MB-13 (GND1) - Body ground | Ground | Always | Below 1 Ω |
Install to the power distribution box assembly the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION
Connect the H23 air conditioning amplifier assembly connectors.
Measure the voltage according to the value(s) in the table below
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| 4C-24 - Body ground*1 | Rear window defogger signal (input) | rear window defogger switch off | Below 1 V |
| rear window defogger switch on | 11 to 14 V | ||
| 4E-43 - Body ground | Rear window defogger signal (output) | rear window defogger switch off | Below 1 V |
| rear window defogger switch on | 11 to 14 V |
*1: for Manual Air Conditioning System
AIR CONDITIONING AMPLIFIER ASSEMBLY (for Automatic Air Conditioning System)
Disconnect the H24 air conditioning amplifier assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| H24-5 (B) - H24-17 (GND) | Power source | Ignition switch off | 11 to 14 V |
| H24-6 (IG+) - H24-17 (GND) | Power source (IG) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | ||
| H24-17 (GND) - Body ground | Ground | Always | Below 1 Ω |
Connect the H24 air conditioning amplifier assembly connectors.
Measure the pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| H24-1 (CANL) - Body ground | CAN communication line | Ignition switch ON | Pulse generation |
| H24-2 (CANH) - Body ground | CAN communication line | Ignition switch ON | Pulse generation |
| H24-7 (LIN1) - Body ground | LIN communication line | Ignition switch ON | Pulse generation |