The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the horn button assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1.REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MULTIPLEX NETWORK BODY ECU
82878
2.REMOVE ECU INTEGRATION BOX LH
Remove the bolt.
Disengage the clamp.
Remove the ECU integration box LH from the instrument panel junction block assembly.
89111
3.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)
|
Remove in this Direction |
Disengage the claws to remove the central gateway ECU (network gateway ECU) as shown in the illustration.
If the ECU integration box LH is deformed or damaged, replace it.
Do not bend the claws more than necessary.