71503A
1.INSPECT OCCUPANT DETECTION SENSOR (REAR SEAT CUSHION PAD SUB-ASSEMBLY)
for RH:
| *a | Component without harness connected
(Occupant Detection Sensor (Rear Seat Cushion Pad Sub-assembly)) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O62-1(E) - O62-2(+) | Occupied | Below 100 Ω |
| O62-1(E) - O62-2(+) | Not occupied | 1 MΩ or higher |
If the result is not as specified, replace the occupant detection sensor (rear seat cushion pad sub-assembly).
for CENTER:
| *a | Component without harness connected
(Occupant Detection Sensor (Rear Seat Cushion Pad Sub-assembly)) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O63-1(E) - O63-2(+) | Occupied | Below 100 Ω |
| O63-1(E) - O63-2(+) | Not occupied | 1 MΩ or higher |
If the result is not as specified, replace the occupant detection sensor (rear seat cushion pad sub-assembly).
for LH:
| *a | Component without harness connected
(Occupant Detection Sensor (Rear Seat Cushion Pad Sub-assembly)) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O61-1(E) - O61-2(+) | Occupied | Below 100 Ω |
| O61-1(E) - O61-2(+) | Not occupied | 1 MΩ or higher |
If the result is not as specified, replace the occupant detection sensor (rear seat cushion pad sub-assembly).