Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR COMBINATION LIGHT ASSEMBLY
|
Protective Tape |
Apply protective tape around the rear combination light assembly as shown in the illustration.
Remove the 2 screws.
| *a | Pin |
| *b | Guide |
|
Remove in this Direction |
Disengage the pin and guide to separate the rear combination light assembly as shown in the illustration.
w/ Blind Spot Monitor:
Disengage the clamps.
Disconnect the 3 connectors to remove the rear combination light assembly.
w/o Blind Spot Monitor:
Disengage the clamp.
Disconnect the 3 connectors to remove the rear combination light assembly.