Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.SEPARATE REAR COMBINATION LIGHT ASSEMBLY
|
Protective tape |
Apply protective tape around the rear combination light assembly.
Remove the 2 screws.
| *a | Pin |
| *b | Guide |
|
Remove in this Direction |
Disengage the pin and guide to separate the rear combination light assembly as shown in the illustration.
2.REMOVE REAR TURN SIGNAL LIGHT BULB
|
Remove in this Direction |
Turn the rear combination light socket with the rear turn signal light bulb as shown in the illustration to remove it.
Remove the rear turn signal light bulb from the rear combination light socket.