Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2020.03–2020.07
RM36W0E _59 Vehicle Exterior _088302 EXTERIOR PANELS / TRIM _0421038 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Install the grommet.

HINT:

Use the same procedure for the RH side and LH side.



b.

Temporarily install the front bumper assembly.


c.

Install the 2 clips and 2 bolts.


d.

Connect the connector.


e.

Pull back the side of the front bumper assembly and connect the connector.

B575058

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.



f.

Engage the clamp.


g.
B577634C01
0,0 0,0 false
V113147

Install in this Direction


Engage the claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



h.

Install the 6 screws.


Hide 47749F 2.INSTALL PIN HOLD CLIP

a.

Engage the claw to install the pin hold clip.

HINT:

Use the same procedure for the RH side and LH side.



Hide 4.ADJUST MILLIMETER WAVE RADAR SENSOR

a.

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.



Hide 5.PERFORM CALIBRATION (w/ Parking Support Brake System)