Centering bolts are used to install the door hinges to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
The specified torque for standard bolts is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
| *a | Centering Bolt |
| *b | Standard Bolt |
67005
1.INSPECT BACK DOOR PANEL SUB-ASSEMBLY
Check that the clearance measurements of areas "A" to "K" are within the standard ranges.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 6.0 to 9.0 mm (0.236 to 0.354 in.) | B | -0.5 to 2.5 mm (-0.0197 to 0.098 in.) |
| C | 6.0 to 9.0 mm (0.236 to 0.354 in.) | D | -0.5 to 2.5 mm (-0.0197 to 0.098 in.) |
| E | 3.0 to 8.0 mm (0.118 to 0.315 in.) | F | 4.8 to 7.8 mm (0.189 to 0.307 in.) |
| G | 4.9 to 8.9 mm (0.193 to 0.350 in.) | H | 3.1 to 8.1 mm (0.122 to 0.319 in.) |
| I | 3.5 to 8.5 mm (0.138 to 0.335 in.) | J | 3.5 to 8.5 mm (0.138 to 0.335 in.) |
| K | 4.2 to 9.2 mm (0.165 to 0.362 in.) | - | - |
58410B
2.REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)
64771G
3.REMOVE SPARE WHEEL COVER
64716D
4.REMOVE DECK TRIM REAR COVER
67005
5.ADJUST BACK DOOR PANEL SUB-ASSEMBLY
Loosen the 4 hinge bolts on the back door and adjust the back door position.
Tighten the 4 hinge bolts on the back door after adjustment.
Use the same procedure for the RH side and LH side.
Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.
Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.
64716D
6.INSTALL DECK TRIM REAR COVER
64771G
7.INSTALL SPARE WHEEL COVER
58410B
8.INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)