84052
1.INSPECT UNLOCK WARNING SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Unlock Warning Switch Assembly) |
| *b | Switch |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H55-1(UN+) - H55-2(UN-) | Pushed | Below 1 Ω |
| H55-1(UN+) - H55-2(UN-) | Not Pushed | 10 kΩ or higher |
If the result is not as specified, replace the unlock warning switch assembly.