The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly (water inlet housing) removal/installation are shown below.
16031
1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
16032
2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
Using an E8 "TORX" socket wrench, remove the stud bolt.
Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block sub-assembly.
Remove the gasket from the engine water pump assembly (water inlet housing).