1.INSPECT RADIATOR CAP SUB-ASSEMBLY
| *a | Rubber packing (1) |
| *b | Rubber packing (2) |
| *c | Rubber packing (3) |
| *d | Valve seat |
Measure the valve opening pressure.
If there are water stains or foreign matter on the rubber packings (1), (2) or (3), clean the part(s) with water and finger scouring.
Check that the rubber packings (1), (2) and (3) are not deformed, cracked or swollen.
Check that the rubber packing (3) and valve seat are not stuck together.
Apply engine coolant to the rubber packings (2) and (3) before using the radiator cap tester.
| *1 | Radiator Cap Sub-assembly |
| *a | Radiator Cap Tester |
| *b | 30° or more |
When using the radiator cap tester, tilt it upwards 30° or more.
Pump the radiator cap tester several times, and check the maximum pressure.
1 pump per second
Even if the radiator cap sub-assembly cannot maintain the maximum pressure, it is not a defect.
| Item | Specified Condition |
|---|---|
| Standard pressure
(for brand-new cap) |
93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13 to 18 psi) |
| Minimum pressure
(for used cap) |
79 kPa (0.8 kgf/cm2, 11 psi) |
If the maximum pressure is less than the minimum pressure, replace the radiator cap sub-assembly.