The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
89348N
2.REMOVE NO. 1 ULTRASONIC SENSOR CLIP
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Disengage the wire harness clamp.
|
Remove in this Direction |
Disengage the claws to remove the No. 1 ultrasonic sensor clip as shown in the illustration.
89341K
3.REMOVE FRONT CORNER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
|
Remove in this Direction |
Disconnect the connector.
Disengage the claws to remove the front corner ultrasonic sensor as shown in the illustration.
89341L
4.REMOVE FRONT CENTER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
|
Remove in this Direction |
Disconnect the connector.
Disengage the claws to remove the front center ultrasonic sensor as shown in the illustration.
89347B
5.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the front corner ultrasonic sensor retainer is necessary.
When removing the front corner ultrasonic sensor retainer, heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Front Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Front Corner Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the front corner ultrasonic sensor retainer.