The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.
1.REMOVE REAR BUMPER ASSEMBLY
89342
2.REMOVE REAR CORNER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
|
Remove in this Direction |
Disconnect the connector.
Disengage the claws to remove the rear corner ultrasonic sensor.
89342A
3.REMOVE REAR CENTER ULTRASONIC SENSOR
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
|
Remove in this Direction |
Disconnect the connector.
Disengage the claws to remove the rear center ultrasonic sensor.
89348R
4.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the rear corner ultrasonic sensor retainer is necessary.
When removing the rear corner ultrasonic sensor retainer, heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Rear Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Rear Corner Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the rear corner ultrasonic sensor retainer.
89348S
5.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the rear center ultrasonic sensor retainer is necessary.
When removing the rear center ultrasonic sensor retainer, heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
Heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
| Item | Temperature |
|---|---|
| Rear Bumper Assembly | 40 to 60°C (104 to 140°F) |
| Rear Center Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the rear center ultrasonic sensor retainer.