Home › Drivetrain › K320 (MULTIDRIVE / CVT) › REVOLUTION SENSOR (NC1 SENSOR) › 2020.03–2020.07
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0422076 REVOLUTION SENSOR(NC1 SENSOR) A

K320 MULTIDRIVE / CVT  REVOLUTION SENSOR(NC1 SENSOR)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission revolution sensor (NC1) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Air intake system parts Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)
Replacement of transmission valve body assembly
1.

Reset memory

2.

Transaxle compensation code (Initialize)

3.

CVT oil pressure calibration


·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:
(Click here)
for Registration:
(Click here)

PROCEDURE

Hide 35410J 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

Hide 89413S 2.REMOVE TRANSMISSION REVOLUTION SENSOR (NC1)

a.
C428878

Disconnect the transmission revolution sensor (NC1) connector.


b.

Remove the bolt and transmission revolution sensor (NC1) from the transaxle case sub-assembly.