Home › Drivetrain › K320 (MULTIDRIVE / CVT) › TRANSMISSION WIRE › 2020.03–2020.07
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0422071 TRANSMISSION WIRE A

K320 MULTIDRIVE / CVT  TRANSMISSION WIRE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission wire removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Air intake system parts Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)
Replacement of transmission valve body assembly
1.

Reset memory

2.

Transaxle compensation code (Initialize)

3.

CVT oil pressure calibration


·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:
(Click here)
for Registration:
(Click here)

PROCEDURE

Hide 35410J 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

Hide 82125M 2.REMOVE TRANSMISSION WIRE

a.
C429255C01
0,0 0,0 false
V113147

Release the lock lever


Release the lock lever and disconnect the transmission wire connector.


b.
C429256

Disconnect the transmission revolution sensor (NC1) connector.


c.
C429257

Remove the bolt and transmission wire from the transaxle case sub-assembly.


d.
C395524

Remove the O-ring from the temperature sensor.