Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › 2020.03–2020.09
RM36W0E _51 Engine / Hybrid System _088664 CRUISE CONTROL _0422126 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic Radar Cruise Control System

·

Lane Tracing Assist System

·

Front Radar Sensor System

·

Pre-collision System

·

Automatic High Beam System


Triangle Target:
(Click here)
or
Flat Surface Target:
(Click here)
or
Driving Adjustment:
(Click here)
ECU security key Vehicle control history (RoB) are stored (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 88211B 2.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.

Disconnect the connector.

A458920C03
0,0 0,0 false
V100135

Bolt
V100136

Screw



b.

Remove the 2 bolts and screw.


c.

Disengage the 2 guides to remove the millimeter wave radar sensor assembly.

NOTICE:

Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.