These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C0 | GPS Antenna Connection Malfunction(short) | Navigation antenna malfunction | ·
Navigation antenna assembly ·
Antenna cord sub-assembly ·
Radio and display receiver assembly |
| B15C1 | GPS Antenna Connection Malfunction(break) | Navigation antenna power source malfunction | ·
Navigation antenna assembly ·
Antenna cord sub-assembly ·
Radio and display receiver assembly |
Check that the antenna cord sub-assembly cable is properly installed and does not have any sharp bends, pinching or loose connections before performing following procedure.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Remove the antenna cord sub-assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL
| *a | Component without harness connected
(Antenna Cord Sub-assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| GS-3 - GP-1 | Always | Below 1 Ω |
| GS-3a - GP-1a | Always | Below 1 Ω |
| GS-3 or GP-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the navigation antenna assembly.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ANTENNA>REMOVAL
| *a | Component without harness connected
(Navigation Antenna Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 3a | Always | 50 to 500 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG