The radio and display receiver assembly receives a reverse signal from the back-up light switch assembly.
The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly.
The radio and display receiver assembly receives a reverse signal from the power distribution box assembly.
Move the shift lever to R and check if the back-up lights come on.
The back-up lights come on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H79 radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H79-28 (REV) - Body ground | Ignition switch ON
Shift lever in R |
11 to 14 V |
| H79-28 (REV) - Body ground | Ignition switch ON
Shift lever not in R |
Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H79 radio and display receiver assembly connector.
Disconnect the 4C power distribution box assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H79-28 (REV) - 4C-2 | Always | Below 1 Ω |
| H79-28 (REV) or 4C-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG