Home › Engine / Hybrid System › M15A-FKS (ENGINE CONTROL) › CAMSHAFT OIL CONTROL SOLENOID (for Intake Side)
RM36W0E _51 Engine / Hybrid System _087499 M15A-FKS ENGINE CONTROL _0422178 CAMSHAFT OIL CONTROL SOLENOID(for Intake Side) G

M15A-FKS ENGINE CONTROL  CAMSHAFT OIL CONTROL SOLENOID(for Intake Side)  INSPECTION  


PROCEDURE

Hide 15370 1.INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

a.

Check the resistance.

i.
A436352C12
1.5,0.229 1.896,0.469 0.396,0.24 0.125,0.104 0.375,0.313 0.25,0.208 10 false *a 1.583,0.26 1.865,0.469 0.281,0.208 10 false D16
*a Component without harness connected
(Camshaft Timing Oil Control Solenoid Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
D16-1 - D16-2 0 °C (32 °F) 5.3 to 6.3 Ω
D16-1 - D16-2 20 °C (68 °F) 5.8 to 6.8 Ω
D16-1 - D16-2 40 °C (104 °F) 6.2 to 7.4 Ω


If the result is not as specified, replace the camshaft timing oil control solenoid assembly.



b.

Stroke Amount Inspection

i.

Using vernier calipers, measure length (A) and (B) with the shaft of the camshaft timing oil control solenoid assembly set in the respective positions shown in the illustration.

NOTICE:

Do not apply auxiliary battery voltage to the terminals of the camshaft timing oil control solenoid assembly .


HINT:

If the shaft does not extend under its own weight, extend the shaft with your fingers.


A436354C03
0,0 0,0 false


ii.

Calculate the stroke amount based on the difference of length (A) and (B).

Standard:

6.5 mm (0.256 in.) or more


HINT:

Stroke amount = length (A) - length (B)


If the value is not as specified, replace the camshaft timing oil control solenoid assembly .