Home › Engine / Hybrid System › M15A-FKS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM36W0E _51 Engine / Hybrid System _087499 M15A-FKS ENGINE CONTROL _0422185 CRANKSHAFT POSITION SENSOR A

M15A-FKS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 28100 1.REMOVE STARTER ASSEMBLY

Hide 11401G 2.REMOVE CRANKSHAFT POSITION SENSOR

a.
A463067

Disconnect the crankshaft position sensor connector.


b.

Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.



c.

Remove the O-ring from the crankshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.

·

If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.