Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422222 CAMSHAFT POSITION SENSOR A

M15A-FXE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 11102A 1.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A463107

Disconnect the camshaft position sensor connector.


b.

Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



c.

Remove the O-ring from the camshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the camshaft position sensor.

·

If the O-ring groove of the camshaft position sensor is damaged, replace the camshaft position sensor with a new one.




Hide 11102A 2.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.

Disconnect the camshaft position sensor connector.


b.
A463108

Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



c.

Remove the O-ring from the camshaft position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the camshaft position sensor.

·

If the O-ring groove of the camshaft position sensor is damaged, replace the camshaft position sensor with a new one.