Home › Steering › STEERING COLUMN › STEERING PAD SWITCH
RM36W0E _55 Steering _087550 STEERING COLUMN _0424132 STEERING PAD SWITCH A

STEERING COLUMN  STEERING PAD SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the steering pad switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 45130 2.REMOVE HORN BUTTON ASSEMBLY

Hide 45116 3.REMOVE NO. 1 STEERING WHEEL ORNAMENT

a.
C433958

Remove the 2 screws.


b.

Disengage the 3 pins to remove the No. 1 steering wheel ornament.


Hide 84250A 4.REMOVE STEERING PAD SWITCH ASSEMBLY

a.
C434161

Disconnect the steering pad switch connector from the spiral cable with sensor sub-assembly.


b.

Disengage the 6 pins to remove the steering pad switch assembly.