Home › Vehicle Interior › HEATING / AIR CONDITIONING › REFRIGERANT LINE › 2020.03–2020.07
RM36W0E _58 Vehicle Interior _088019 HEATING / AIR CONDITIONING _0424495 REFRIGERANT LINE A

HEATING / AIR CONDITIONING  REFRIGERANT LINE  INSTALLATION  


PROCEDURE

Hide 88718L 1.INSTALL PIPING CLAMP

a.

Remove the vinyl tape from the open ends of the suction pipe sub-assembly and suction hose sub-assembly.


b.
I113108C01
0.833,1.771 0.833,1.438 false 1.531,0.625 1.323,0.354 false 1.354,0.781 1.146,0.51 true 0.75,1.792 0.917,1.958 0.167,0.167 10 false *1 1.115,0.271 1.427,0.427 0.313,0.156 10 false *2 0.938,0.427 1.25,0.583 0.313,0.156 10 false *a
*1 Suction Hose Sub-assembly
*2 Piping Clamp
*a Groove


Install a new piping clamp to the suction hose sub-assembly.

NOTICE:
·

Securely engage the inside step of the piping clamp in the suction hose sub-assembly groove.

·

Do not widen the opening of the piping clamp more than the diameter of the suction hose sub-assembly when installing it.

·

Do not install the piping clamp with the large diameter section in the wrong direction.




c.

Thoroughly coat 2 new O-rings and contact surface of the suction hose sub-assembly with compressor oil.

Compressor Oil:
for Gasoline Model:

ND-OIL 8 or equivalent

for HV Model:

ND-OIL 11 or equivalent



d.

Install the 2 O-rings to the suction hose sub-assembly.

NOTICE:

Do not let foreign matter adhere to the O-rings or O-ring seals.



e.
I115531C04
0.771,0.781 0.979,0.438 false 2.302,1.573 2.302,1.115 true 0.427,1.5 0.427,1.135 true 1.021,0.375 1.333,0.531 0.313,0.156 10 false *a 2.24,1.583 2.552,1.74 0.313,0.156 10 false *b 0.365,1.521 0.677,1.677 0.313,0.156 10 false *b
*a Large Diameter Section of Piping Clamp
*b Alignment Mark


Engage the suction pipe sub-assembly and suction hose sub-assembly by matching the alignment marks.

NOTICE:

Engage the parts by holding the pipe, not the piping clamp.



f.
I103973C01
1.219,0.469 1.385,0.823 true 1.021,0.354 1.229,0.521 0.208,0.167 10 *a
*a Large Diameter Section of Piping Clamp


Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the suction pipe sub-assembly.

NOTICE:
·

When inserting, make sure that a click sound is heard.

·

Check that the suction hose sub-assembly is securely inserted by pulling it.