88625Q
1.INSPECT COOLER (ROOM TEMP. SENSOR) THERMISTOR
Check the resistance.
| *a | Component without harness connected
(Cooler (Room Temp. Sensor) Thermistor) |
| *b | Sensing Portion |
| *c | Resistance (kΩ) |
| *d | Temperature (°C (°F)) |
| *e | Allowable Range |
Measure the resistance according to thevalue(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H58-1 (+) - H58-2 (-) | 10°C (50°F) | 3.00 to 3.73 kΩ |
| H58-1 (+) - H58-2 (-) | 15°C (59°F) | 2.45 to 2.88 kΩ |
| H58-1 (+) - H58-2 (-) | 20°C (68°F) | 1.95 to 2.30 kΩ |
| H58-1 (+) - H58-2 (-) | 25°C (77°F) | 1.60 to 1.80 kΩ |
| H58-1 (+) - H58-2 (-) | 30°C (86°F) | 1.28 to 1.47 kΩ |
| H58-1 (+) - H58-2 (-) | 35°C (95°F) | 1.00 to 1.22 kΩ |
| H58-1 (+) - H58-2 (-) | 40°C (104°F) | 0.80 to 1.00 kΩ |
| H58-1 (+) - H58-2 (-) | 45°C (113°F) | 0.65 to 0.85 kΩ |
| H58-1 (+) - H58-2 (-) | 50°C (122°F) | 0.50 to 0.70 kΩ |
| H58-1 (+) - H58-2 (-) | 55°C (131°F) | 0.44 to 0.60 kΩ |
| H58-1 (+) - H58-2 (-) | 60°C (140°F) | 0.36 to 0.50 kΩ |
Hold the cooler thermistor (room temperature sensor) only by its connector. Touching the sensing portion may change the resistancevalue.
When measuring, the cooler thermistor (room temperature sensor) temperature must be the same as the ambient temperature.
As the temperature increases, the resistance decreases (see the graph).
If the result is not as specified, replace the cooler (room temp. sensor) thermistor.