Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR GLASS › 2020.03–2020.09
RM36W0E _59 Vehicle Exterior _088018 WINDOW / GLASS _0424524 BACK DOOR GLASS A

WINDOW / GLASS  BACK DOOR GLASS  REMOVAL  


PROCEDURE

Hide 76811B 1.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH

Hide 85110R 2.REMOVE REAR WIPER MOTOR ASSEMBLY

Hide 81570 3.REMOVE CENTER STOP LIGHT SET

Hide 4.REMOVE REAR SPOILER ASSEMBLY (w/ Rear Spoiler)

Hide 68131 5.REMOVE BACK DOOR GLASS

a.

Disconnect each connector and disengage each clamp.


b.
B572484C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape to the area around the installation position of the back door glass on the back door panel to prevent it from being scratched.


c.
B563205C03
1.333,0.521 1.313,0.958 1.313,0.958 1.51,0.813 true 1.219,1 1.448,1.188 0.229,0.188 10 true *a
*a Matchmark


Place matchmarks on the back door glass and back door panel at the locations indicated in the illustration.

HINT:

Matchmarks are not necessary if the back door glass is not going to be reused.



d.
B563195C02
2.792,1.958 2.677,1.729 false 2.75,1.99 3.063,2.146 0.313,0.156 10 false *a
*a Piano Wire


Pass a piano wire between the back door panel and back door glass from the interior.


e.

Tie both wire ends to wooden blocks or similar objects that can serve as handles.


f.

Cut the adhesive by pulling the piano wire around the back door glass.

NOTICE:
·

When separating the back door glass, take care not to damage the paint or interior and exterior ornaments.

·

When cutting the adhesive, take care not to damage the connectors on the back door glass.

·

Do not pull the piano wire in a vertical direction, but pull it in a horizontal direction.




g.

Using suction cups, disengage the No. 1 back window glass spacer and No. 2 back window glass spacer to remove the back door glass.

NOTICE:
·

To prevent the back door glass from falling when performing this operation, be sure to hold the back door glass using suction cups.

·

Be careful not to drop the back door glass.

·

Leave as much adhesive on the back door panel as possible when removing the back door glass.




Hide 64813B 6.REMOVE BACK WINDOW GLASS ADHESIVE DAM

a.

When reusing the back door glass:

i.
B563196C02
0.104,0.083 0.417,0.281 0.313,0.198 10 false *a
*a Back Side of Back Door Glass


Using a scraper, remove the back window glass adhesive dam.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the back window glass adhesive dam with a new one.





Hide 64813B 7.REMOVE NO. 2 BACK WINDOW GLASS ADHESIVE DAM

a.

When reusing the back door glass:

i.
B563197C01
0.104,0.115 0.417,0.271 0.313,0.156 10 false *a
*a Back Side of Back Door Glass


Using a scraper, remove the No. 2 back window glass adhesive dam.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the No. 2 back window glass adhesive dam with a new one.





Hide 75574C 8.REMOVE NO. 1 BACK WINDOW OUTSIDE MOULDING LH

a.

When reusing the back door glass:

i.
B563198C02
0.156,0.104 0.469,0.302 0.313,0.198 10 false *a
*a Back Side of Back Door Glass


Using a scraper, remove the No. 1 back window outside moulding LH.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the No. 1 back window outside moulding LH with a new one.





Hide 75573G 9.REMOVE NO. 1 BACK WINDOW OUTSIDE MOULDING RH

HINT:

Use the same procedure as for the LH side.


Hide 64828B 10.REMOVE BACK WINDOW GLASS CLIP LH

a.

When reusing the back door glass:

i.
B563199C02
0.094,0.083 0.406,0.281 0.313,0.198 10 false *a
*a Back Side of Back Door Glass
V100155

Adhesive Tape


Apply adhesive tape to the glass at the edges of the back window glass clip LH as shown in the illustration to mark the installation position of the back window glass clip LH.

NOTICE:

Because the adhesive tape will be used to position the back window glass clip LH during installation, do not remove the adhesive tape.



ii.

Using a scraper, remove the back window glass clip LH.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the back window glass clip LH with a new one.





Hide 64827B 11.REMOVE BACK WINDOW GLASS CLIP RH

HINT:

Use the same procedure as for the LH side.


Hide 62785F 12.REMOVE BACK DOOR GLASS SPACER

a.

When reusing the back door glass:

i.
B563200C01
0.094,0.125 0.406,0.281 0.313,0.156 10 false *a
*a Back Side of Back Door Glass


Using a scraper, remove the 2 back door glass spacers.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the back door glass spacer with a new one.