Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0424557 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Blind spot monitor sensor Blind spot monitor beam axis adjustment Blind Spot Monitor System (Click here)

PROCEDURE

Hide 2.REMOVE REAR BUMPER ASSEMBLY

Hide 88172 3.REMOVE BLIND SPOT MONITOR SENSOR LH

a.
E437238

Disconnect the connector.

NOTICE:

Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.



b.

Remove the 3 nuts and blind spot monitor sensor LH.


Hide 88162 4.REMOVE BLIND SPOT MONITOR SENSOR RH

HINT:

Use the same procedure described for the LH side.