Home › Engine / Hybrid System › M15A-FKS (STARTING) › STARTER › 2020.03–2020.07
RM36W0E _51 Engine / Hybrid System _089409 M15A-FKS STARTING _0424573 STARTER A

M15A-FKS STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)


b.

Connect the engine wire to terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter assembly connector.


e.

Engage the 3 clamps to install the No. 4 water by-pass hose and engine wire to the bracket.


Hide 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

a.
A466067

Align the protrusion with the cylinder block sub-assembly and attach the claw as shown in the illustration to install the flywheel housing side cover.

NOTICE:
·

Make sure the claw makes a click sound, indicating that it fits tightly.

·

Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.




Hide 3.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

a.

Connect the air cleaner hose to the throttle body assembly and tighten the hose clamp.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


b.

Connect the No. 2 ventilation hose to the cylinder head cover sub-assembly and slide the clip to secure it.


c.

Engage the 3 grommets to install the air cleaner assembly with air cleaner hose to the vehicle body.


d.

Engage the clamp.


e.

Connect the connector.


Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function thatcompletes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART