33402
1.INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY
Using a caliper gauge, inspect the reverse idler gear sub-assembly.
25.056 to 25.074 mm (0.9865 to 0.9872 in.)
25.074 mm (0.9872 in.)
If the inside diameter exceeds the maximum, replace the reverse idler gear sub-assembly.
Using a micrometer, inspect the reverse idler gear shaft.
24.984 to 25.000 mm (0.9836 to 0.9843 in.)
24.984 mm (0.9836 in.)
If the outer diameter is less than the minimum, replace the reverse idler gear shaft.