Home › Brake › BRAKE (REAR) › REAR BRAKE › 2020.03–2020.07
RM36W0E _54 Brake _089429 BRAKE (REAR) _0424715 REAR BRAKE(for LHD) G

BRAKE (REAR)  REAR BRAKE(for LHD)  INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR BRAKE DRUM INSIDE DIAMETER

a.
F006408

Using a brake drum gauge or the equivalent, measure the inside diameter of the brake drum.

Inside diameter:
Standard Maximum
200 mm (7.87 in.) 201.0 mm (7.91 in.)


If the inside diameter is greater than the maximum, replace the brake drum.


Hide 2.INSPECT REAR BRAKE SHOE LINING THICKNESS

a.
F042690

Using a ruler, measure the thickness of the shoe lining.

Thickness:
Standard Minimum
4.0 mm (0.157 in.) 1.0 mm (0.0394 in.)


If the lining thickness is equal to or less than the minimum value, or if there is any severe or uneven wear, replace the brake shoe.

NOTICE:

If the brake shoes need replacing, they must be replaced as a set.



Hide 3.INSPECT REAR BRAKE DRUM AND REAR BRAKE SHOE LINING FOR PROPER CONTACT

a.
C151738

Apply chalk to the inside surface of the drum, then grind the brake shoe lining so that they fit together properly.

If the contact between the drum and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.


Hide 4.INSPECT REAR WHEEL BRAKE CYLINDER

a.

Check the cylinder bore and piston for rust and scoring.