1.INSPECT PARKING BRAKE LEVER TRAVEL
Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
5 to 8 clicks
2.ADJUST PARKING BRAKE LEVER TRAVEL
Remove the No. 1 box side panel.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX>REMOVAL
Remove the No. 2 box side panel.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX>REMOVAL
Remove the console rear end panel.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX>REMOVAL
Remove the upper No. 1 console support bracket.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX>REMOVAL
Completely release the parking brake lever.
| *1 | No. 1 Wire Adjusting Nut |
Turn the No. 1 wire adjusting nut until the parking brake lever travel is corrected to within the specified range.
5 to 8 clicks
If the lock nut has been removed from the rod, replace the No. 1 wire adjusting nut with a new one.
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
Check whether the parking brake drags or not.
Install the upper No. 1 console support bracket.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX>INSTALLATION
Install the console rear end panel.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX>INSTALLATION
Install the No. 1 box side panel.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX>INSTALLATION
Install the No. 2 box side panel.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR CONSOLE BOX>INSTALLATION
3.INSPECT BRAKE WARNING LIGHT
When operating the parking brake lever, check that the brake warning light illuminates.
Brake warning light always illuminates at the first click.