Home › General › MAINTENANCE › M15A-FKS AUXILIARY BATTERY › 2020.03–2020.07
RM36W0E _V1 General _088300 MAINTENANCE _0424838 M15A-FKS AUXILIARY BATTERY A

MAINTENANCE  M15A-FKS AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A464257

Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.


Hide 28800 3.REMOVE AUXILIARY BATTERY

a.
A464258

Disengage the 4 claws and remove the connector cover from the positive (+) auxiliary battery terminal.


b.
A464259

Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.


c.

Remove the bolt and No. 2 battery clamp from the battery clamp sub-assembly in the order shown in the illustration.

A464260E01
2.885,2.135 3.042,2.333 0.156,0.198 10 false 1 6.563,0.813 6.719,1.01 0.156,0.198 10 true 2 5.583,1.135 5.74,1.333 0.156,0.198 10 true 3


d.

Remove the auxiliary battery from the vehicle.