Home › General › MAINTENANCE › M15A-FXE AUXILIARY BATTERY
RM36W0E _V1 General _088300 MAINTENANCE _0424839 M15A-FXE AUXILIARY BATTERY A

MAINTENANCE  M15A-FXE AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.



Hide 76973F 2.REMOVE REAR UNDER SIDE COVER RH

a.
A464091

Remove the 2 clips.


b.

Disengage the clips and guides to remove the rear under side cover RH.


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A464142

Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.


Hide 4.REMOVE AUXILIARY BATTERY

a.
A476038

Remove the bolt and No. 2 battery clamp.


b.
A464143

Disconnect the battery hose from the auxiliarybattery.


c.
A476039

Move the auxiliary battery toward the front of the vehicle.


d.
A476040

Disengage the 2 claws and open the connectorcover.


e.

Loosen the nut and disconnect the cable from thepositive (+) auxiliary battery terminal.


f.

Remove the auxiliary battery.