Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (for HV Model)
RM36W0E _51 Engine / Hybrid System _088664 CRUISE CONTROL _0424997 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for HV Model) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for HV Model)  U059481  Invalid Data Received from Hybrid Powertrain Control Module Invalid Serial Data Received  


DESCRIPTION

If the hybrid vehicle control ECU cannot recognize the millimeter wave radar sensor assembly. DTC U059481 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U059481 Invalid Data Received from Hybrid Powertrain Control Module Invalid Serial Data Received Approximately 17 seconds or more after the ignition switch is turned to ON, the hybrid vehicle control ECU cannot recognize the millimeter wave radar sensor assembly for approximately 2 seconds or more. Hybrid vehicle control ECU Radar Cruise2

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.


PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
50002 426

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTCs
2.CHECK FOR DTCs
a.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



b.

Check for DTCs.

Powertrain > Radar Cruise2 > Trouble Codes
50001 426

Result:
Result Proceed to
DTC U059481 is not output A
DTC U059481 is output B



A

B